- Configuring Microagent receiver in the BaseN Platform
- Configuring BaseN Platform in Meshlium
- Start BaseN Cloud Connector
- Verify BaseN Cloud Connector synchronization
BaseN
Follow this short instruction to get Meshlium synchronized to BaseN Platform running. This guide assumes that you are already a customer of BaseN and have access to your BaseN admin wiki.
Configuring Microagent receiver in the BaseN Platform
In your chosen wiki page, configure the following minimum setup for synchronizing with the BaseN Platform.
- Id: Unique ID of this Microagent receiver.
- Path: Measurement data path for data storage.
- Username: Username for authentication of Microagent receiver.
- Password: Password for authentication of Microagent receiver.
Configuring BaseN Platform in Meshlium
Use the same Microagent receiver parameters in the Meshlium BaseN Cloud Connector plugin.
BaseN plugin is located in:
Manager System -> Cloud Connector -> Basic Cloud Partner -> BaseN
- BASEN_URL: Usually http://customername.basen.com/_ua/customername/.
- BASEN_ID: Unique ID of this Microagent receiver.
- BASEN_USER: Username to authenticate the Microagent receiver.
- BASEN_PASSWORD: Password to authenticate the Microagent receiver.
After setting the parameters, save the configuration clicking on the "Save" icon.
Start BaseN Cloud Connector
Click on "Start" for Cloud Synchronization. A green icon should start rolling to indicate synchronization is running.
Verify BaseN Cloud Connector synchronization
Go to the BaseN Platform wiki where the Microagent Receiver and MicroAgentConfig were configured, and check under "Debug Information for <id>" and "Stats" that the Observer Request Counts does show requests arriving.